I believe this was caused by the horrendous layer adhesion of this silk PLA. Didn't have time to tune the filament, and based it off of another silk one.
Few years ago I had similar issues with silk PLA - until I accidentally sliced it with a prusa PETG profile. Came out absolutely perfect. Since then I just treat silk PLA like prusa PETG.
Actually it seems like your bed slipped halfway (see the sudden misalignment on Y axis clearly visible on the bowl) and even though printer kept printing well afterwards, it propably reached some point where it started printing "into the air"
Everything that was supposed to be attached at the bottom of the bowl, wasn't. There were three poles and some sort of tower, all with small footprints. All the supports weren't attached either. I also could easily separate the layers with minimal force.
I think you're right that a bed slip caused a chain reaction, but the layer adhesion certainly didn't help.
aard
in reply to anguo • • •anguo
in reply to aard • • •CaptainBlagbird
in reply to aard • • •aard
in reply to CaptainBlagbird • • •Meron35
in reply to anguo • • •like this
Azathoth likes this.
ouRKaoS
in reply to Meron35 • • •Imgonnatrythis
in reply to anguo • • •AngrySquirrel
in reply to anguo • • •Schmaker
in reply to anguo • •3DPrinting reshared this.
anguo
in reply to Schmaker • • •Everything that was supposed to be attached at the bottom of the bowl, wasn't. There were three poles and some sort of tower, all with small footprints. All the supports weren't attached either. I also could easily separate the layers with minimal force.
I think you're right that a bed slip caused a chain reaction, but the layer adhesion certainly didn't help.
Schmaker likes this.
Schmaker
in reply to anguo • •I consider this information important as this mean it's not sticking for some (not hot enough or not enough material?) reason.
I only had splittable (not that easily though) layers with ABS/ASA, never with PLA or PETG
3DPrinting reshared this.
anguo
in reply to Schmaker • • •billwashere
in reply to anguo • • •